Table of Contents
Advertisement
Faults and what to do about them
en
Drain the water. ~ Page 41
3.
Pull the emergency release
4.
downwards with a tool and release.
The door can then be opened.
Information on the display panel
Display
Œ
Hot
|
E:36
alternating with
-10
H:95
alternating with
End
when programme is
finished
H:32
alternating with
End
when programme is
finished
44
Cause/Remedy
Flashes fast + signal: The door was opened and the water level is too high.
■
Close the door, continue the programme with I button or select Empty pro-
gramme.
Flashes slowly: The door lock temperature is too high to open the door. Wait
■
approx. 30 seconds until the door lock temperature cools down.
The temperature in the drum is too high. Wait for the appliance running to cool
down the laundry till the Hot disappears on the display panel, then the door can be
opened.
Flashes (no water supply): Water tap turned on? Filter in the water supply is
■
blocked?
~ "Filter in the water supply is blocked" on page 42
Is the supply hose kinked or trapped?
Lights up (low water pressure): For information only. This will not affect the
■
programme progress. The programme duration is extended.
Drain pipe or water drain hose is blocked. Clean the drain pipe and the water
■
outlet hose.
Drain pipe or water drain hose is caught or jammed. Ensure that the drain pipe
■
and water drain hose are not kinked or trapped.
The drain pump is blocked.
■
~ "Drain pump is blocked" on page 41
The drain hose at the siphon is blocked.
■
~ "The drain hose at the siphon is blocked" on page 42
The water drain hose is connected too high. Install the water outlet hose at a
■
maximum height of 1 meter.
~ "Hose and cable lengths" on page 16
No water detected in drying phase, may get bad drying result.
The unbalanced load detection system has interrupted the spin cycle because the
laundry is unevenly distributed. Distribute small and large items of laundry evenly in
the drum.
Advertisement
Table of Contents
