Renishaw OMP40-2 Installation Manual page 42

OMP40-2 installation guide
Symptom
Machine stops
unexpectedly during a
probing cycle.
8.2
Probe crashes.
Cause
Optical communication obstructed.
Interface/receiver/machine fault.
Dead batteries.
False probe trigger.
Probe unable to find target
surface.
Adjacent probe.
Workpiece obstructing probe path.
Probe length offset missing.
Controller wired to respond to tool
setter instead of inspection probe.
Action
Check interface/receiver and
remove obstruction.
Refer to interface/receiver/
machine user's guide.
Change batteries.
Enable enhanced trigger filter.
Check that part is correctly
positioned and that stylus has not
broken.
Reconfigure adjacent probe to low
power mode and reduce range of
receiver.
Review probing software.
Review probing software.
Review installation wiring.