I/O Address - Advantech MIC-3612/3-BE User Manual

To remove a card:
1. Push the handle down to unlock the card, then the CPCI system will automati-
cally uninstall the card configuration.
2. Once the system finished the device configuration, the Blue LED on the front
panel will turn on. Now you can slide the card out.
Note! Advantech MIC-3612's "Hot-Swap"function complies with CPCI Hot
Swap Specification PICMG 2.1 R2.0.
Note! Because of the "Hot-Swap", the above steps detail the card removal pro-
cess while the system is on.
If the system power is off, please follow step1 and step2 and disregard
the status of the Blue LED.
2.3

I/O Address

In this section, you will learn to set an I/O base address for the MIC-3612.
Base address setting
When the MIC-3612 is installed in the system or if the machine is first turned on, the
configuration software must scan the various buses in the system. If the software
locates the MIC-3612, the system will configure the device based on the parameters
of the PCI device configuration registers, including the I/O base address, I/O range,
memory base address, memory range, and so forth. The I/O base address is the
base address on the four ports of the MIC-3612 card. The four ports address are as
shown:
Base Address Setting
CH 1
CH 2
CH 3
CH 4
MIC-3612/3-BE User Manual
Base Add. + 00H
Base Add. + 08H
Base Add. + 10H
Base Add. + 18H
6