Information; Temperature - SHOWTEC Compact Par 7 Q4 User Manual

Compact Par 7 Q4
02) Press the SETUP button to enable configuration of the settings.
03) Press the UP/DOWN buttons to select the setting.

Information

In this menu you can see the temperature of the LEDs and the firmware version.
01) Press the UP/DOWN buttons to toggle between the following 2 options:
02) Press the SETUP button to view the parameter.

Temperature

In this submenu you can see the temperature of the LEDs. The display shows one of the following 2
indications:
Attention
Switch off the device, if the display shows that the temperature of the LEDs is too high.
Product code: 42584
Fail Behavior of the device in case of DMX failure
(OFF/HOLD). If you select OFF, the device will black
out the light output if there is no DMX signal. If you
select HOLD, the device will use the last properly
received DMX signal.
Sync Synchronization over DMX (ON/OFF). Enable this
option to activate the synchronization of the output
of the built-in chases across all devices connected
on one DMX link.
Reset Reset the device to the default factory settings
(NO/YES). After reset the device will start up in auto
run mode.
Temp See 6.6.8.1. Temperature on page 23 for more information.
Version Firmware version of the device
23
The temperature of the LEDs is normal.
The temperature of the LEDs is too high.