Prepare The Slide Assemblies - Intel SRPM8 Quick Start Manual

Prepare the Slide Assemblies

1. Remove the slide assemblies from the kit.
2. Orient the slide assembly so that the arrow embossed on each rail assembly is facing toward
the front of the server as shown in Figure 2.
3. Secure each slide rail to the server using 3 of the 8-32 csink screws as shown in Figure 3.
4. Fully extend the telescoping slide assembly until the center bar hits the safety latch on the
small outer bar (all three overlapping bars will be visible).
5. Grasp the small outer bar (attached to the server) with your right hand so that your thumb is on
the safety latch of the small outer bar.
8 SRPM8 Server System Quick Start Guide
Figure 2. Slide Rail Orientation
Figure 3. Slide Rail Mounting Screws