Table of Contents
Advertisement
• Device Address: If your Smart Interface is part of a Network, enter the Network Address here. The default network
Note:
The default Device Address is 1.
• Device IP or Port: The COM port number that your device is connected to on your computer.
Important:
The following parameters should NOT be changed. These settings should NOT be changed unless the
configuration has been done on the interface.
• BaudRate: Controls bits per second
• DataBits: The number of 'bits' in each character sent.
• Parity: A means of checking correctness of character by adding an extra 'bit' to the character and setting the value
based on all the other bits in the character.
• StopBits: The number of 'bits' used to indicate the end of the character.
Once you have completed setting the communication parameters for your device, click Finish.
4.3
Process Inputs Interface
The SP-014 can accept up to three 0-24 mA or 0-1.0 VDC process inputs. To customize your process inputs, follow these
steps:
Step 1:
Click the Inputs configuration tab on SYNC and choose your input type from the Type dropdown.
Step 2:
Choose between mA and mV from the Device Range/Type drop down.
address is 1 for most devices. Please refer to the manual of your Smart Interface for more
information.
9 |
P a g e
Advertisement
Table of Contents
