Electrical Preparations - treesse Rest Preinstallation Manual

Pre-Installation
6

ELECTRICAL PREPARATIONS

The Treesse minipools are built in compliance with
European laws (EN 60 335-2-60) and are tested during
production to ensure the safety of the installer and user.
The electrical preparations are to be performed by a
suitably qualified and certified electrician.
All electrical preparations must be performed only
after disconnecting the electricity in the work area.
The electrical connection must be:
• Performed in a fixed and permanent manner, without
intermediate splices, in accordance with regulations of
the country of installation.
• Sufficient for the current absorbed by the bathtub
(see technical specifications).
• Provided with a functioning ground as per current
regulations.
• Protected against splashing water, then placed
in a dedicated room, closed and sheltered from the
weather.
Local regulations prohibit any electrical installation (plug sockets, switches, lamps, etc.) in the area surrounding
the minipool for a distance of at least 60 cm and a height of 230 cm.
EN
• Controlled by a multi-pole switch with a contact gap of
• Controlled by a differential switch no larger than
The control unit's power supply cable must be of the H05
type with three wires (single-phase 220V) or five wires
(three-phase 380V) whose gauges are adequate for the
absorption of the minipool (see "Pre-installation sheet").
Its size depends on the absorbed current and the distance
of the minipool from the main electrical cabinet.
In addition, if the bathtub is installed outdoors, the power
cord from the main electrical panel to the minipool must
pass through an underground duct, adequately protected
against freezing with insulation.
sheet or tampering with any electrical component of the
minipool.
m i
n .
6 0
c m
n .
m i
c m
6 0
15
at least 3 mm and a breaking capacity equal to 60A (or
in any case adequate for the absorption of the bathtub).
30mA.
The Manufacturer is not responsible for connections
made in a way that does not comply with local
codes, the specifications in this pre-installation
n .
m i
c m
6 0
m i
n .
6 0
c m
m i
n .
6 0
c m
Rest
minipool