Berbel Glassline BEH 60 GL Operating And Installation Instructions For The Models page 26

Cleaning
Lower section
The lower section is held in the device by two pins at the
sides.
☞ Fold the lower section down.
1.
2.
☞ Press the lower section up.
☞ Pull on the lower section at the side with both hands and
draw it approx. 10 mm forwards.
☞ Lift the rear lower section out.
☞ Clean the lower section with a soft, moist cloth or in a
dishwasher.
☞ Dry the lower shell with a soft cloth.
Upper shell and bulging edge
The upper section is permanently attached to the device.
The bulging edge is attached and held in the device by
magnets.
26
☞ Pull the bulging edge from the upper shell.
☞ Clean the upper section with a soft, moist cloth.
☞ Clean the bulging edge, such as in a dishwasher.
☞ Make sure the bulging edge is completely dry.
☞ Dry the upper shell with a soft cloth.
Capillar Trap
The Capillar Trap is inserted and is held in the device through
a side lock.
☞ Grasp the Capillar Trap on its sides with both hands.
☞ Pull the Capillar Trap out.
☞ Clean the Capillar Trap e.g. in a dishwasher.
☞ Clean the surfaces and edges on the recess for the
Capillar Trap with a soft, moist cloth.
☞ Make sure that the Capillar Trap is completely dry.
After cleaning, the interior parts should be reinserted.
D "3.5.9 Insert the capillary trap, bulging edge and lower
shell" (page 19).
6005145_0 – 27.02.2020