Advertisement
Table of Contents
Over Armour Offroad
CAUTION: Do not smoke inside the cab or expose the enclosure to direct flames. Product is
Be sure to read these instructions thoroughly before opening and installing the enclosure.
The installation is best done when the temperature is 60
carton and unroll the enclosure on a large flat surface that is clean and free of dirt or other
material.
Check over the parts included in the carton with the parts list shown below:
Velcro hook strips
Velcro hook strips
Velcro hook strips
Snap Studs
Cab Enclosure
1. You must remove the windshield and top(if installed) before beginning
installation of the Soft Door Kit.
2. Begin by attaching the top of the door to the cross bars running front to back on
the roll cage using the supplied 19" adhesive Velcro strips. Pull the door up and
mark where the Velcro on the top of the door is going to hit the bar, make sure
that the cab is centered across the back by checking both sides and making sure
they both hit the front bars equally. Now apply the 19" adhesive Velcro on the bar
facing inboard, and attach the corresponding Velcro straps on the enclosure(see
fig. 2
2505 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of
Kawasaki
Soft Door Kit
KAW-SX-SDK01
FLAMMABLE.
24 each
2 each
2 each
17 each (1 extra)
2 doors
Mule SX
°
F or warmer. Carefully open the
3" long
8" long
19" long
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Over Armour Offroad KAW-SX-SDK01
Summary of Contents for Over Armour Offroad KAW-SX-SDK01
- Page 1 Over Armour Offroad 2505 Bypass Rd. Flemingsburg, KY 41041 606-845-7439 Instructions for Installation and Care of Mule SX Kawasaki Soft Door Kit KAW-SX-SDK01 CAUTION: Do not smoke inside the cab or expose the enclosure to direct flames. Product is FLAMMABLE.
- Page 2 Fig.2 3. Next you will work your way down the front of the door. Starting at the top you will see double-sided Velcro strips sewn to the edge of the cab. At these points you will take the 3” adhesive Velcro and wrap them around the bar and then wrap the double-sided strip around that to provide a secure grip.
- Page 3 Cleaning and Storage Recommendations: 1. Before removing the enclosure for storage, make sure it is clean and dry, to prevent soiling the textile and scratching the clear vinyl side/rear windows. Clean with a soft rag or sponge using a mild liquid detergent soap and warm water solution.
- Page 4 - a 25% restocking fee will apply. If ordered from Over Armour Offroad please call at 606-845-7439 to gain a return authorization number, use our preferred shipping carrier (UPS) to return the item (unless the item is defective, you are responsible for paying the shipping to return the item.) Any...
- Page 5 Warranty To The Owner of this Product: Thank you for purchasing one of Over Armour Offroad Cab Enclosures, Tops &/or Windshields! Below are the terms under which your product is covered under our manufacturer’s warranty. 30 Day Warranty which includes and is not limited to replacing the enclosure, tops and/or windshield due to defect of the product.
Need help?
Do you have a question about the KAW-SX-SDK01 and is the answer not in the manual?
Questions and answers