Over Armour Offroad KAW-3010TRANS-FC01 Instructions For Installation And Care

Over Armour Offroad
Instructions for Installation and Care of 3010 Trans Full Cab Enclosure
Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable.
1. Be sure to read these instructions thoroughly before unrolling and installing the
Mammoth Designs 3010 Trans Full Cab Enclosure. The installation is best done
when the temperature is 65 degrees F. or warmer.
2. Carefully unroll the Cab Enclosure on a large flat surface that is clean and free of
dirt, preferably on grass lawn.
3. Check over the parts included in the carton with the parts list shown below:
Velcro Hook strips:
"
"
"
"
Snap studs
Cab Enclosure
4. The Cab enclosure will be in 4 separate pieces when removed from the boxes,
windshield/top, 2 side door panels, and a rear window. To begin, loosely drape
the windshield/top over the top of the Mule roll cage. Note the correct position
for the 16" latch strip on the brush guard at the front of the Mule. Clean the area
with Isopropyl alcohol, let dry and apply the Velcro hook strip. Then attach the
Cab to the strip around the brush guard.
5. Working your way to the rear of the roll cage, fit the Cab into position. You will
now need to wrap the bars with the 6" adhesive hook strips directly above the air
intake vents on either side of the roll cage. Firmly grasp the rear corners of the
windshield/top and pull them down to the Velcro. Once you have brought the two
pieces of Velcro together you will first wrap one side of the double-sided Velcro
around the bar and then wrap the other side around to overlap itself creating a
strong and secure hold. At this point you may need to adjust the nose piece and
either loosen or tighten it before moving forward. Next locate the double-sided
2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
KAW-3010TRANS-FC01
8 each
"
1 each
"
1 each
"
12 each
"
2 each
11 each (1 extra)
1 each
8" long
16" long
43" long
3" long
11" long (1"wide)