Error Indicators - Hanseatic HGTI4582E97736BS User Manual

Problem
The LED (13) is
illuminated, although
dishwasher salt has
been added.
The water is not run-
ning or it is running only
very slowly.
The water is not run-
ning off or only very
slowly.
The dishwasher is not
watertight.
The dishwasher can be
switched on/off, but not
cannot be operated.
The dishwasher cannot
be operated.

Error indicators

Code
flashing rapidly
It takes too long for the
water to fill up.
flashing rapidly
Water overflow
flashing rapidly
flashing rapidly
Required temperature not
reached.
Possible cause
The dishwasher salt is
clumpy.
There is a kink in the inlet
hose.
The water tap is not on
properly.
The filters are blocked.
The outlet hose is kinked,
has been extended or is
hanging too high up/too low.
The door seal is defective.
The outlet hose or the inlet
hose is defective.
The dishwasher can only be
operated when the door is
closed.
The buttons are locked.
Solution
Turn the water tap on completely.
Arrange the inlet hose properly so that it is not kinked
(see "Connecting the inlet hose" on page EN-29).
Ensure that the water pressure is correct. See "Technical specifi-
cations" on page EN-41.
Switch off the tap. Find the gap in the seal (or have someone find
it) and repair the leak (or have it repaired).
Malfunction in the heating element. Have the appliance examined
and repaired.
Troubleshooting table
Solution
Stir the dishwasher salt using the
end of a spoon or similar.
Lay out the inlet hose in such a man-
ner that it is not kinked.
Turn the water tap on completely.
Clean the filters (see page EN-26).
Lay out the outlet hose in the proper
manner (see page EN-29).
Have the door seal replaced
(see "Service" on page EN-39).
Have the defective hose replaced
(see "Service" on page EN-39).
Close the door.
Unlock the buttons (see "Button
lock" on page EN-23).
Page EN-37