Powering Up; Power Up Sequence - Ambient Weather FALCON WS-8480 User Manual

No Description
1 Wind vane
2 Wind cups
3 Antenna
4 Thermo-hygrometer
5 Thermo-hygrometer sensor
6 Mounting pole bracket (fits 35 – 40 mm
diameter pole (1" – 1.75")
7 3 x AA battery compartment
3.4

Powering Up

3.4.1 Power Up Sequence

Note: The power up sequence must be performed in the order shown in this section (remote
transmitters FIRST, Display Console SECOND) to avoid sensor synchronization time out.
The Indoor Wireless Transmitter(s):
1. Remove the battery door on the sensor(s)
2. If you have more than one sensor, make sure each sensor is on a different channel (reference
Figure 2).
3. Insert 2 x AA batteries into the battery compartment.
4. Replace the battery door.
The Outdoor Sensor Array:
1. Unscrew the battery door at the bottom of the sensor array, and insert 3 x AA batteries
according to the polarity information marked on the battery compartment.
2. Replace the battery door and screw on tightly.
3. The transmission status LED will begin flashing once per 12 seconds.
The Console:
Important Note: The power up sequence must be performed in this order (battery first, AC
adapter second) to prevent a low battery indication at power up.
1. Place the two wireless sensors about 5 to 10 feet from the display console.
2. Remove the battery door of the main console and insert three fresh AAA batteries.
3. Replace the battery door
4. Plug the AC adaptor into the DC jack of the console.
5. After power up, all of LCD segments will be displayed. The console will enter access point
(AP) mode, and the status LED will flash green.
6. Do not touch any buttons until sensor synchronization is complete.
Version 1.2 ©Copyright 2019, Ambient LLC. All Rights Reserved.
radiation shield
Figure 4
No Description
[RESET] button
8
9 Transmission status LED (flashes when
transmits)
10 Bubble level
11 Rain collector
12 UV / Light Intensity sensor
13 Solar panel
Page 8