Installer Parameters - Salus BTRP230V Full User Manual

6. Installer parameters

To enter installer parameters please follow steps below. Please refer to parameters table description before any changes. Use
up or down between all parameters. Every change/selection confirm by
1
3 sec.
Hold +
to enter the installer mode.
3
Press button to confirm.
dXX Function
d01 Heating Control
d02 Room temp. offset
d03 OUT sensor probe (S1/S2)
d04 Air sensor or Floor sensor
3 sec.
buttons for 3 seconds
Parameter
Values
This parameter defines the algorithm of the room temperature control.
0
1
2
-3.0°C to
+ 3.0°C
0
1
0
1
button:
2
Use
4
Select installer parameter by or
buttons. Use
change parameter value.
Confirm choice by
PWM (Pulse-width modulation) algorithm ensures reduction of overdrive
states and economic operation of the system. It is an advanced algorithm
designed to precisely maintain room temperature.
SPAN ± 0.25°C (± 0.5°F)
SPAN ± 0.5°C (± 1.0°F)
Offset room temperature measuring is a function which allows user to
recalibrate internal thermostat's temperature sensor by a given number of
degrees (in the range from -3,0 °C to 3,0 °C in 0,5°C steps).
Out sensor probe not connected
Out sensor probe connected
Air sensor: If parameter d03 is inactive (d03 = 0) then internal sensor
controls the temperature
Air sensor: If parameter d03 is active (d03 = 1) then internal sensor is
disabled and OUT sensor controls the temperature
Floor sensor: If parameter d03 is inactive (d03 = 0) then internal sensor
controls the temperature
Floor sensor: If parameter d03 is active (d03 = 1) then internal sensor is
disabled and OUT sensor controls the floor protection temperature
or to choose
code „49".
3
or buttons to
button.
Description
or buttons to move
Default
Values
0
0.0°C
0
0
25