Information On Display Panel; Malfunctions - IKEA DISKAD Manual

FAULT
Excessive formation of
foam occurs.

Information on display panel

FAULT
Special salt refill indic-
ator lights up.
Refill indicator for spe-
cial salt does not light
up.
Refill indicator for rinse
aid lights up.
Refill indicator for rinse
aid does not light up.

Malfunctions

FAULT
Water is left in the ap-
pliance at the end of
the programme.
CAUSE
Rinse aid has been
spilled.
Detergent or appliance
care product used
causes excessive foam-
ing.
CAUSE
Insufficient special salt.
Sensor does not detect
special salt tablets.
Water softening sys-
tem is switched off.
Insufficient rinse aid.
Rinse aid system is
switched off.
CAUSE
Filter system or area
under the filters is
blocked.
Programme has not
yet ended.
TROUBLESHOOTING
Remove the rinse aid with a
●
cloth.
Change the brand of deter-
●
gent.
TROUBLESHOOTING
Add Special salt → Page 28.
●
Do not use special salt tab-
●
lets.
Setting water softening sys-
●
tem → Page 28
Add Rinse aid → Page 30.
1.
Set the amount of rinse aid
2.
to be dispensed.
Set the amount of rinse aid
●
to be dispensed.
→ "Setting the amount of rinse
aid", Page 30
→ "Setting the amount of rinse
aid", Page 30
TROUBLESHOOTING
Clean the Filters → Page 42.
1.
Clean the Wastewater pump
2.
→ Page 57.
Wait until the programme
●
ends or cancel the pro-
gramme with reset.
→ "Terminate programme",
●
Page 37
54