Table of Contents
Advertisement
Before using for the first time
Before using for the first time
Configure the settings for initial start-
up.
Performing the initial config-
uration
On initial start-up or after a reset to the
factory settings, you will need to make
settings.
Requirement: The appliance has been
installed and connected. → Page 14
Water softening system
Water softening system
Hard water leaves limescale on the tub
and tableware and parts of the appli-
ance may become blocked.
To ensure good dishwashing results,
you can treat the water with special salt
and the water softening system. To
Overview of water hardness settings
You can find an overview of the water hardness values that can be selected here.
You can find out how hard your water is from your local water company or by using
a water hardness tester.
WATER HARDNESS
°E
0 - 8
9 - 10
11 - 12
13 - 15
16 - 20
21 - 26
27 - 38
39 - 62
HARDNESS RANGE MMOL/L
Soft
Soft
Medium
Medium
Medium
Hard
Hard
Hard
Add special salt. → Page 28
1.
Add rinse aid. → Page 30
2.
Switch on the appliance. → Page 36
3.
Setting the water softening system.
4.
→ Page 28
Set the amount of rinse aid to be dis-
5.
pensed. → Page 30
Tip: You can change these settings and
other Basic settings → Page 38 at any
time.
avoid damage to the appliance, water
with a hardness above 9 °E must be
softened.
0 - 1.1
1.2 - 1.4
1.5 - 1.8
1.9 - 2.1
2.2 - 2.9
3.0 - 3.7
3.8 - 5.4
5.5 - 8.9
SETTING VALUE
H:00
H:01
H:02
H:03
H:04
H:05
H:06
H:07
27
Advertisement
Table of Contents
