Table of Contents
Advertisement
BASIC SETTING
Time-beam-on-
floor
Start programme
Tone volume
Button volume
Factory setting
DISPLAY
SELECTION
TEXT
S:01
S:00 - S:01
SP:01
SP:00 - SP:01
SL:02
SL:00 -SL:03
bl:02
bl:00 - bl:03
rE
Start with
DESCRIPTION
Switch Time-beam-on-floor on
or off.
While the programme is run-
ning, status information is
projected onto the floor be-
low the appliance door relat-
ing to timer programming,
the programme or the time
remaining. If the base panel is
pulled forwards or if the ap-
pliance is installed at eye level
with the cabinet front fitted
flush, the display is not vis-
ible.
Level "S:00" switches the
Time-beam-on-floor of.
Set a default programme for
when the appliance is
switched on.
With the setting "SP:00",
●
the last programme selec-
ted is set by default for
when the appliance is
switched on.
With the setting "SP:01",
●
the Eco 50° programme is
set by default for when the
appliance is switched on.
Adjustment of tone volume.
End of programme indicated
by an audible signal tone.
Level "SL:00" switches the sig-
nal tone off.
Set the button volume during
operation. Level "bl:00"
switches the button tones off.
Restore changed settings to
the factory settings.
The settings for initial start-up
must be configured.
40
Advertisement
Table of Contents
