Table of Contents
Advertisement
Switching off water softening
system
Note
To avoid damage to the appliance, only
switch off the water softening system in the
following cases:
The water hardness is max. 26 °E and
●
you are using combined detergents
with salt replacement substances. Ac-
cording to manufacturers, combined
detergents with salt replacement
substances can generally only be
used up to a water hardness of 26 °E
without adding special salt.
The water hardness is 0 - 8 °E. You do
●
not need to use special salt.
Press
.
1.
To open the basic settings, press
2.
for 3 seconds.
The display shows H:xx.
a
Overview of consumption values with regeneration the water
softening system
Here you can find an overview of the maximum additional running time and con-
sumption values during regeneration of the water softening system.
You can find the column applicable to your model in the quick reference guide ac-
cording to its water consumption in the Eco 50° programme.
WATER CON-
SUMPTION IN
LITRES (DE-
PENDING ON
MODEL)
6.5 / 6.7
7.5 / 7.7
9.5
above 10.5
REGENERA-
ADDITIONAL
TION OF THE
RUNNING
WATER
TIME IN
SOFTENING
MINUTES
SYSTEM AFTER
X RINSE
CYCLES
8
7
7
7
6
7
5
7
The display shows
a
Press
or
3.
display shows H:00.
To save the settings, press
4.
for 3 seconds.
The water softening system is
a
switched off and the salt refill indic-
ator is deactivated.
Regeneration of the water
softening system
In order to obtain fault-free function of
the water softening system, the appli-
ance performs reheating of the water
softening system at regular intervals.
Regeneration of the water softening
system takes place before the end of
the main rinse cycle in all programmes.
It will increase the run time and con-
sumption values, e.g. water and electri-
city.
ADDITIONAL
WATER CON-
SUMPTION IN
LITRES
5
5
5
5
.
repeatedly until the
ADDITIONAL
POWER CON-
SUMPTION IN
KWH
0.05
0.05
0.05
0.05
29
Advertisement
Table of Contents
