Table of Contents
Advertisement
FAULT
Coloured deposits (yel-
low, orange, brown)
that are easy to re-
move are present in-
side the appliance
(mainly at the bottom).
Plastic parts inside the
appliance are discol-
oured.
Plastic parts are discol-
oured.
Removable streaks are
present on glasses,
glassware with a
metallic appearance
and cutlery.
CAUSE
The formation of films
is due to ingredients of
food remnants and tap
water (limescale)
"soaplike".
Plastic parts inside the
appliance may become
discoloured during the
life of the dishwasher.
Washing temperature
is too low.
Tableware has been
precleaned too in-
tensely. The sensors
chose a weaker pro-
gramme. Stubborn
soiling cannot be en-
tirely removed.
Amount of rinse aid to
be dispensed is set too
high.
No rinse aid has been
added.
Detergent residue is
present in the final
rinse. Lid of the deter-
gent dispenser is
blocked by tableware
items and will not open
fully.
TROUBLESHOOTING
Check the setting of the wa-
1.
ter softening system.
Add special salt.
2.
→ "Adding special salt",
Page 28
If you are using combined
3.
detergents (tabs), activate
the water softening system.
Follow the information about
detergents.
→ "Information on deter-
gents", Page 32
Discolouration can come
●
about and will not impair
functioning of the appliance.
Select a programme with a
●
higher washing temperat-
ure.
Only remove large remnants
●
of food and do not prerinse
tableware.
Adjust the sensitivity of the
●
sensors.
Set the rinse aid system to a
●
lower setting.
→ "Adding rinse aid", Page 30
●
Arrange tableware in the top
1.
basket tableware so the tab
collecting tray is not obstruc-
ted by tableware.
→ "Arrange tableware",
Page 35
Items of tableware are block-
ing the dispenser lid.
Do not place tableware or
2.
fragrance dispensers in the
tablet collecting tray.
52
Advertisement
Table of Contents
