IN GENERAL
1.4. LABELS USED ON THE CHAIR
Warning
Icon
Icon
Labels
Labels on the chair should be read at a distance of approx. 40 cm under
normal daylight conditions.
For labels related to the operation of the chair, please refer to section 2.0.
1.5. SAFETY
This chair is CE marked and com-
plies with applicable EU regulations.
The chair is manufactured by:
VELA, Gøteborgvej 8-12,
9200 Aalborg SV, Denmark.
The VELA Tango with electrical func-
tions meets all safety requirements
according to IEC 60601-1, including
requirements for EMC according to
IEC60601-1-2.
Risk of shear and squeeze:
Keep hands and fingers away from moving parts
Read "Instruction For Use" before use
Part used:
Type B cf. IEC60601-1
covering the following areas of the chair:
60 x 22,5 mm
This label only applies to
chairs with electrical functions:
The chair is IP21 approved, which corresponds
to protection against water droplets, as well as
against touching dangerous parts with a finger.
<Model name>
<Model ref no.>
<Manufacturer>
<Adress>
<Webpage>
<IdentNo.>
IdentNo.:
Follow instructions
for use
EN60601-1
IP21
Blade fuse: 10A/32V,
1.5.1. APPLICATION
This chair is an indoor chair inten-
ded for sitting and private use.
:: The chair is not built to stand on
:: The wheel brake must always be
activated when sitting down or
standing up
All variants of this chair are tested
and approved for a maximum load
of 80 kg.
<ME Equipment mass>
<Safe Working load>
<Production date/order no.>
Input:
24V
0.5A
Duty cycle: 10%,
max. 2min/18min Storage limits
60°C
-20°C
7