TABLE OF CONTENTS 1.0. INTRODUCTION 1.1. WARNINGS 1.2. TROUBLESHOOTING 1.3. VELA TANGO WITH ELECTRIC HEIGHT ADJUSTMENT 1.3.1. Power input 1.3.2. Emission 1.3.3. Surge protection 1.4. LABELS USED ON THE CHAIR 1.5. SAFETY 1.5.1. Application 1.5.2. Transport 1.6. WARRANTY 1.7. UNPACKING THE CHAIR 1.8.
1.0. INTRODUCTION DEAR CUSTOMER Congratulations on your new VELA chair! We are sure this chair will give you daily pleasure. This user manual provides useful information on adjusting, operating and maintaining your chair. Important Please read this user manual carefully and keep it safe for when you need to refer to it.
1.1. WARNINGS In case of an allergic reaction, stop using the chair and consult a doctor Only use original spare parts from VELA Only use the supplied charger for charging the chair Do not make any changes to the accessories that come with the chair...
See section 2.0.12 Brake rod seems loose The hand screw holding the brake rod might be loose. Tighten the screw. See section 2.0.22. If the above does not solve your problem, you should contact your VELA supplier.
Current: 0.5A Power: 12VA 1.3.2. EMISSION A VELA chair with electrical functions has been tested and complies with current requirements regarding electromagnetic radiation (EMC requirements). The chair is tested to the following specifications: :: Emission class CISPR 11, Group 1, Class B See more details at www.vela.eu...
VELA, Gøteborgvej 8-12, :: The wheel brake must always be 9200 Aalborg SV, Denmark. activated when sitting down or The VELA Tango with electrical func- standing up tions meets all safety requirements according to IEC 60601-1, including All variants of this chair are tested...
- 10°C. :: Instructions for use 1.6. WARRANTY :: Charger (only for chairs with elec- VELA grants a right of claim under trical functions) applicable law in the country where the chair is acquired. The right of Note: see item 2.0.1 for correct complaint applies only when using attachment of backrest.
1.8.4. RECYCLING GUIDE Your VELA chair can be reused by another person when you no longer need it as long as the chair is ser- It is important that you return your viced by a technician beforehand.
Can be operated from the underside of either the right or left armrest. The armrest can easily be moved to the opposite side. VELA Tango El is also available with height adjustment via hand VELA box (if caregivers are to be able to adjust the height).
Note: Setting the angle of backrest and seat should always be done with your feet flat on the floor. 2.0.4. SETTING ANGLE OF SEAT Adjusted by pulling up the middle handle on the right-hand side. 2.0.5. SETTING ANGLE OF BACKREST Adjusted by pulling up the rear handle on the right-hand side.
STD. BACK 2.0.8. BACK BOLT (HIGH BACK)* The backrest can be set to a specific angle by adjusting and attaching the bolt mounted on the back of the backrest. 2.0.9. ADJUSTING THE ARMREST HEIGHT Adjusted by loosening the screw on the armrest bar and adjusting the height of the armrest.
2.0.12. ROTATION The seat is rotated by pushing back on the front handle on the left-hand side. Rotation can be turned and locked in the following positions: 90° to the left, 0° (neutral), and 90° to the right. 2.0.13. BRAKE The brake is activated by moving the handle on the side of the chair forward.
2.0.18. CHARGING (EL) VELA Daily charging is recommended . Remove the operation plug TANGO from the back of the armrest and place it in the charger as shown.
TANGO The hand box is used via push buttons on the front. VELA hand boxes can have one or more functions. The icons on the hand box show the button functions. Note: Insert plug in hand box to operate functions.
See a complete list of accessories at: www.vela.eu Note: Charger is included as an accessory when purchasing a VELA chair with electrical functions. Depending on model www.vela.eu VELA :: Gøteborgvej 8-12 :: 9200 Aalborg SV :: Denmark :: Tel: +45 96 34 76 00 :: mail@vela.dk...