Foot Plate; Rotation (Vela Tango 100S) (Optional); Rotation (Vela Tango 100Es) (Optional); Push Handle (Optional) - Vela Tango 100S Instructions For Use Manual

VELA
TANGO
100S
VELA
TANGO
100ES

2.0.13. FOOT PLATE

The foot plate can be adjusted in length by loosening the hand
screw in the center of the rod on the footrest. Remember to
tighten the screw afterwards. The foot plate can be folded up
so that it does not interfere when getting in and out of the chair.
Note: When adjusting the height of the footplate, always have
the chair height in lowest position to avoid damage on the chair.

2.0.14. ROTATION (VELA TANGO 100S) (OPTIONAL)

By pulling up the lever situated on the back left side, you can
rotate the seat 90° in either direction. The seat will lock into at
stable position, when turning the seat.

2.0.15. ROTATION (VELA TANGO 100ES) (OPTIONAL)

By pushing the lever situated on the front right side, you can
rotate the seat 90° in either direction. The seat will lock into at
stable position, when turning the seat.
The rotation can remain open, if you heave the lever outwards.

2.0.16. PUSH HANDLE (OPTIONAL)

Push handle for transporting a person in the chair. The push
handle should be mounted on the back wheel towers.
Note: The push handle is also available in a configuration that can
be adjusted in height. Loosen the screw located in the middle of
the rod. Adjust the height. Remember to tighten the screw.
1 3