Service - Oregon 710-120 Original Instruction Manual

Maintenance and Service
4. Set the chain pusher switch to ON.
5. Place a 0.019" (0.05 mm) feeler gauge (B)
between the lifting arm (C) and the flange
(A) and make sure that the lifting arm
completely meets the flange for about 1.5
seconds before it lifts again.
B
C
• If the test is successful, the wire does not
need to be adjusted. The test is finished.
• If the lifting arm and flange do not
completely meet or do not meet long
enough, perform the next steps.
• If the wire is damaged or worn, it must be
replaced; see section 8, "Accessories and
Spare Parts" When it has been replaced,
repeat steps 1-8.
6. Set the chain pusher switch to OFF.
30
593357aa_AutoChainGrinder_710-120_OM.indd 30
A
7. To set the wire so that the lifting arm meets
the flange:
• for a shorter time: turn the two nuts (D) in
the direction towards the machine.
• for a longer time: turn the two nuts (D) in
the direction from the machine.
D
8. Repeat steps 5-8 until the test is
successful.

6.6 Service

WARNING The user must only perform
maintenance that is described in this manual.
Only approved and trained service technicians
can service the machine.
Note: Keep the delivery crates and packing
material. Pack the machine carefully if it is
moved or sent for service. The crates and
packing material will minimize the risk of
damage during transportation.
710-120
3/1/17 12:03 PM