Table of Contents
Advertisement
Operation
4.
Press the grinding head positioning button
to move the grinding head in both
directions and make sure that the top-plate
angles are the same.
5.
If the top-plate angles are not the same (for
example 26° in the right direction and 30°
in the left direction), adjust the nuts (A) a
1/2-turn at the time.
6.
Repeat steps 2-5 until the top-plate angles
are the same in both directions.
5.2.4 Inserting the chain
1.
Check the chain for double-links (2 left
cutters or 2 right cutters) or joint-links, and
make sure that the chain is not damaged.
Mark double-links or joint-links to make
it easier to see them when the chain is
sharpened.
2.
Attach the stop clamp on a tie-strap
between a double-link or a joint-link.
20
593357aa_AutoChainGrinder_710-120_OM.indd 20
A
3.
Place the chain, with the cutter to the left of
the depth gauge, into the groove on the
chain vise.
4.
Attach the chain weight to the chain.
5.
Pull the chain around by hand to make sure
that it runs freely in the chain vise.
CAUTION Always wear gloves and
protective eyewear while you work and
operate your grinder.
710-120
3/1/17 12:03 PM
Advertisement
Table of Contents
