Download Print this page

Installation  Safety  Notes - B-Tech System X BT8371-2X2 Installation Manual

Universal mobile video wall stand for 2x2 video walls

Advertisement

INSTALLATION SAFETY INSTRUCTIONS
CAUTION:
 
use  only  with  the  maximum  weights  indicated.  Use  with
flat  screens  heavier  than  the  maximum  indicated  may  result  
  in  instability  causing  possible  injury.
 
 
 
Do  not  attempt  to  install  this  product  until  all  instructions  and  warnings  have  been  read  and  
properly  understood.  Please  keep  these  instructions  for  future  reference.  
Please  check  carefully  to  make  sure  there  are  no  missing  or  defective  parts  -­  defective  parts  must  never  be  used.    
B-­Tech  International  Limited,  its  distributors  and  dealers  are  not  liable  or  responsible  for  
damage  or  injury  caused  by  improper  installation,  improper  use  or  failure  to  observe  these  
safety  instructions.  In  such  cases,  all  guarantees  will  expire.  
 
  General
 
Great  care  must  always  be  taken  during  installation  as  most  AV  equipment  is  of  a  fragile  nature,  
possibly  heavy  and  easily  damaged  if  dropped.  
If  you  do  not  fully  understand  the  instructions  or  are  not  sure  how  to  install  this  product  safely,  then  
please  consult  a  professional  for  advice  and/or  to  install  this  product  for  you.  Failure  to  mount  this  
product  correctly  may  cause  serious  injury  or  death  both  during  installation  and  at  any  time  thereafter.
Do  not  mount  any  AV  equipment  that  exceeds  the  specific  weight  limit  of  the  product  you  are  
installing.  This  weight  limit  will  be  clearly  stated  on  each  product  and  its  packaging  and  will  vary  from  
product  to  product.  
 
Product  location  
 
Please  pay  careful  attention  to  where  this  product  is  located.  Some  locations  are  not  suitable  for  
installation.  
If  located  in  a  public  or  frequently  populated  area  ensure  that  the  product  is  out  of  the  immediate  
reach  of  people.    
 
Fixing  hardware  
 
It  is  highly  recommended  that  all  fixing  screws  be  used  where  supplied  and  that  the  purpose  of  all  
other  fixing  hardware  is  fully  understood.  In  some  cases  more  AV  equipment  fixing  hardware  will  be  
supplied  to  accommodate  different  models  of  equipment  and  set  up  configurations.  
The  installer  must  be  satisfied  that  any  supplied  fixing  hardware  is  suitable  for  each  specific  
installation.  If  any  fixing  screws  or  included  hardware  are  deemed  not  sufficient  for  a  safe  installation  
then  please  consult  a  professional  or  your  local  hardware  store.  
 
Hazard  limitation  
 
When  routing  cables  take  advantage  of  any  built  in  cable  management  features  that  the  product  might  
provide  and  ensure  that  all  cables  are  tidy  and  secure.  Check  to  see  that  any  moving  aspect  of  the  
product  can  do  so  unhindered  by  any  cabling.  
Some  products  have  moving  parts  and  the  potential  to  cause  injury  through  the  crushing  or  trapping  of  
fingers  or  other  body  parts.  
Particular  attention  to  the  nature  of  moving  parts  is  required  especially  when  assembling  installing  and  
adjusting  during  set  up.  
Immediately  after  installations  double-­check  that  the  work  done  is  safe  and  secure.  Double-­check  all  
necessary  fixings  are  present  and  are  of  ample  tightness.  
It  is  recommended  that  periodic  inspections  of  the  product  and  its  fixing  points  are  made  as  frequently  
as  possible  to  ensure  that  safety  is  maintained.  If  in  doubt  consult  a  professional  AV  installer  or  other  
suitably  qualified  person.  
 
2
This  stand/trolley  is  intended  for    
 
 

Advertisement

loading