Remote Controlled Chirp Muting - Directed Electronics Matrix RS 2 Owner's Manual

disarm your vehicle security system. To disarm the system
without a transmitter, you must have the vehicle's ignition key
and know where the Valet switch is located. Be sure to check
with your installer at the time of installation for both the loca-
tion and the preset response (1-5 presses) of the Valet switch.
To disarm the security system without a transmitter:
Turn the ignition on and press the
Valet switch the preset number of
times within 15 seconds. If the
system does not disarm, you may have waited too long; turn the
ignition off and repeat the process.
Location of Valet Switch_________________________________
➜

remote controlled chirp muting

Use the Remote Controlled Chirp Muting to temporarily turn
off the arm or disarm confirmation chirps by briefly pressing
before either arming or disarming the security system.
The confirmation chirp(s) will then be eliminated for that one
operation only. To permanently turn off the arm and disarm
confirmation chirps, contact your installation dealer.
note: The Warning Zone response to lighter impacts is
bypassed if the system is armed using the Remote
Controlled Chirp Muting. This ensures that the siren
does not chirp in an environment where you don't want
chirps to be emitted. The system is still capable of being
triggered by heavier impacts; only the Warning Zone
response generated by light impacts is bypassed.
12
DRW-35
© 2001 directed electronics, inc.