Directed Electronics Matrix RS 2 Owner's Manual page 21

To enter Timer Mode:
1. Start the vehicle by pressing and releasing
2. Press and release
3. Within two seconds press and release
4. The engine will shut down and the parking lights will flash
four times. The engine will then restart to confirm that
Timer Mode has been entered.
The engine may be allowed to run for the pre-programmed time,
or it can be shut down while running during Timer Mode operation
by pressing
three hours for a total of six operation cycles. If the system receives
a shut-down input while the engine is running in Timer Mode, the
engine will stop, but will restart, on schedule, again in three hours!
To exit Timer Mode:
Timer Mode can be exited by turning the ignition on with the
key any time the engine is not running. You can also exit Timer
Mode with the remote transmitter by following these steps:
1. Start the engine by pressing
2. Press and release
3. Within two seconds press and release
4. The engine will shut down and the parking lights will flash
four times to confirm that Timer Mode has been exited. If
the car has already been remote started, skip Step One.
18
.
again. In either case, the vehicle will restart every
.
.
.
again.
again.
© 2001 directed electronics, inc.