q q u u i i c c k k r r e e f f e e r r e e n n c c e e g g u u i i d d e e
Arming
➤
To arm, press
the parking lights will flash once.
Arming While Driving
➤
To arm the system while driving, press
vehicle is running. The system will chirp once and then once more to indi-
cate that the ignition is on.
Disarming
➤
To disarm, press
flash twice.
Siren Silencing
➤
For siren silencing, press
sounding. To completely disarm the security system, press
the system will chirp 4 or 5 times (reporting the trigger).
Disarming Without a Transmitter
➤
Turn on the ignition. Press the Valet switch within 15 seconds. The system
should now disarm. If it does not, you may have waited too long, so turn the
ignition off and on and try again.
Remote Controlled Chirp Muting
➤
Pressing
mation chirp(s) for that one operation only.
Panic Mode
➤
Press and hold
to stop panic mode at any time.
Remote Engine Starting
➤
Press
. The parking lights will turn on (if connected) and the vehicle will
start and run for the programmed period of time.
Disabling Remote Engine Starting
➤
To disable the remote start, move the shutdown toggle switch to the OFF
position.
Location of Valet Switch______________________________
Number of Valet Switch Pulses for Disarming__________________
© 2001 directed electronics, inc.
. When the system arms, you will hear a short chirp, and
. You will hear two chirps, and the parking lights will
on your transmitter and the siren will stop
briefly before arming or disarming will eliminate the confir-
down for 1.5 seconds to activate Panic Mode. Press
on your transmitter while the
again and
33
Need help?
Do you have a question about the Matrix RS 2 and is the answer not in the manual?
Questions and answers