P P O O W W E E R R S S A A V V E E R R M M O O D D E E; P P R R O O G G R R A A M M M M I I N N G G O O P P T T I I O O N N S S - Directed Electronics Matrix RS 2 Owner's Manual

p p o o w w e e r r s s a a v v e e r r m m o o d d e e

Your system will automatically enter Power Saver Mode while
armed or in Valet Mode, after a period of time in which no oper-
ation has been performed. This lowers the current draw to
prevent the system from draining the vehicle's battery. Power
Saver Mode takes over under the following conditions:
➤ ➤
Power Saver when the system is armed:
been armed for 24 hours, the LED will flash at half its
normal rate, decreasing the system's current draw.
➤ ➤
Power Saver in Valet Mode:
Mode the LED illuminates steadily. If the vehicle is not used
(ignition is not turned on) for a period of one hour while the
system is in Valet Mode, the LED will shut off. If the system
remains in Valet Mode, the LED will come back on the next
time the ignition is turned on and then back off.

p p r r o o g g r r a a m m m m i i n n g g o o p p t t i i o o n n s s

➤ ➤
Active arming
matic arming 30 seconds after the last door has been closed).
➤ ➤ Arming/disarming siren chirps
➤ ➤
Auto-Lock/Auto-Unlock with Smart Relocking
When this feature is programmed on, the doors will lock
three seconds after the ignition is turned on, and unlock
when the ignition is turned off. The system can also be
26
When the system enters Valet
(transmitter only) or passive arming (auto-
or off.
on
© 2001 directed electronics, inc.
After the system has
or off:
on