Operating Instructions Dear Customer, Many thanks for the confidence you have shown in us with the purchase of your new JET-product. This manual has been prepared for the owner and operators of a JET JCDC-1.5 cyclone dust collector to promote safety during installation, operation and maintenance procedures.
Do not use this dust collector for other than its determine that it will operate properly and intended use. If used for other purposes, JET perform its intended function. Check for disclaims any real or implied warranty and...
Page 5
plastic or rock can cause sparks and/or 31. Do not put any objects into the openings. Do damage when coming into contact with any not use with any opening blocked; keep free of part of the dust collector. dust, lint, hair, and anything that may reduce air flow.
Page 6
2.0 Direction / Safety Label Figure 1 Shows the general saftey rules to operate this machine Figure 2 Product Brand Logo Figure 3 Machine ID label : Shows the machine’s specifications and series number Figure 4 Warns user of hazardous voltage, and Figure 5 Warns user of heated hot surface should be open up by trained personnel only.
3.0 Specifications Model number ............................JCDC-1.5 Stock number ............................717515M Motor and electricals: Motor type ................ .totally enclosed fan cooled, induction, capacitor start Horsepower ..........................1-1/2 HP (1.1kW) Phase ................................single Voltage ................................. 230V Cycle ................................50Hz Listed FLA (full load amps) ..........................8 A Start capacitor ..........................
Page 8
Shipping weight, approximate ....................144 lb. (65.5 kg) The specifications in this manual were current at time of publication, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations.
4.3 Tools required for assembly Lift main housing (A) using hoist with straps through lifting rings atop main housing. If hoist Hex keys, 4mm and 5mm (provided) is not available, at least 2 persons must lift Open-end wrench, 10/12mm (provided) housing.
Page 11
11. Apply foam tape (T) around inlet port near edge. See Figure 10. The foam tape should Install side cover (M) on left and right stands. completely encircle the port. See Figure 7. 12. Install inlet adaptor (I) on main housing and secure with pan head screw (HP1).
Figure 12 Figure 14 The bag frame maintains the shape of the bag in the negative-pressure environment of the cyclone drum. Assemble bag frame as follows: 5.0 Electrical connections 18. Screw the short and long frame supports into the hoops in alternating manner, as shown in Figure 13.
If repair or replacement of the electric cord or plug is Contact your nearest JET distributor for a line of necessary, connect equipment- Dust Collector hoses and accessories. You can grounding conductor to a live terminal.
8.0 Optional accessories Part no. Description 717511 Canister collection bag for JCDC (package of 5) 717516 Drum collection bag for JCDC-1.5 (package of 5) Table 2 9.0 Troubleshooting the JCDC-1.5 9.1 Electrical and motor problems Symptom Possible Cause Correction* Check connections at plug or circuit No incoming current.
9.2 Performance problems Symptom Possible Cause Correction Hose improperly secured at dust Inspect and remedy. origination point. Inlet port is open. Cap unused inlet ports. Collection bag is full. Empty bag (check sight window). Inspect drum for leaks, make sure lid is Collection drum not sealed properly.
Need help?
Do you have a question about the JCDC-1.5 and is the answer not in the manual?
Questions and answers