Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Jet JDC-501
Summary of Contents for Jet JDC-501
- Page 1 This .pdf document is bookmarked Operating Instructions and Parts Manual Metal Dust Collector Model JDC-501 427 New Sanford Road LaVergne, Tennessee 37086 Part No. M-414700 Ph.: 800-274-6848 Revision C1 09/2018 www.jettools.com Copyright © 2015 JET...
-
Page 2: Important Safety Instructions
Do not use this metal dust collector for other than 21. Turn off the machine before cleaning. Use a its intended use. If used for other purposes, JET brush or compressed air to remove chips or disclaims any real or implied warranty and holds debris —... - Page 3 31. Never mix ferrous and non-ferrous metal dust in WARNING: Some dust, fumes and gases the same dust collector. If you are not familiar created by power sanding, sawing, grinding, drilling, with the proper and safe usage of metal dust welding and other construction activities contain collection systems do not use until proper training chemicals known to the State of California to cause...
-
Page 4: Table Of Contents
If there are questions or comments, please contact your local supplier or JET. JET can also be reached at our web site: www.jettools.com. -
Page 5: Specifications
The specifications in this manual were current at time of publication, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations. -
Page 6: Setup And Assembly
B if a properly grounded outlet is not available. The temporary adapter should be used only until a The JDC-501 Dust Collector is rated at 115/230V properly grounded outlet can be installed by a power, pre-wired for 115 volt, and supplied with a qualified electrician. -
Page 7: Voltage Conversion
No adapter is available or should be used with this tool. If the tool must be reconnected for use on a different type of electric circuit, the reconnection Ampere Total length of Volts Rating cord in feet should be made by qualified service personnel; and after reconnection, the tool should comply with More all local codes and ordinances. -
Page 8: Maintenance
Number of your machine available when you call will allow us to serve you quickly and accurately. Non-proprietary parts, such as fasteners, can be found at local hardware stores, or may be ordered from JET. Some parts are shown for reference only, and may not be available individually. -
Page 9: Jdc-501 Dust Collector - Exploded View
9.1.1 JDC-501 Dust Collector – Exploded View... -
Page 10: Jdc-501 Dust Collector - Parts List
37 ....TS-1482021 ....Hex Cap Screw ............M6x12 ......2 38 ....JDC-500038G ... Bracket......................1 ....JET-165 ..... JET Logo (not shown) ..........165 x 68mm ....1 ....JDC500-ID ....I.D. Label (not shown) ................... 1... -
Page 11: Jdc-501 Dust Collector Wiring Diagram
10.0 JDC-501 Dust Collector Wiring Diagram 115 V 230 V... -
Page 12: Warranty And Service
JET sells through distributors only. The specifications listed in JET printed materials and on official JET website are given as general information and are not binding. JET reserves the right to effect at any time, without prior notice, those alterations to parts, fittings, and accessory equipment which they may deem necessary for any reason ®...