Using For The First Time; Where Is The Identification Plate - V-ZUG Unimatic S Operating Instructions Manual

3

Using for the first time

The appliance must be installed and connected to the electricity supply in
accordance with the separate installation instructions. Have a qualified fitter/
electrician carry out the necessary work.
The appliance was tested with water before being shipped. There may
therefore still be traces of water left in the appliance.
Transport lock
Before using the appliance for the first time, the transportation lock
must be removed (3 screws with washers at the back of the appli-
ance), in order to avoid damage to the appliance.
Running the first wash cycle without any washing
Run an empty wash cycle to remove any residues from the manufacturing
process.
Add a little washing detergent to compartment II.
Select coloureds 60 °C.
3.1

Where is the identification plate?

1 Identification plate with serial number
(FN)
Note down the serial number (FN) of your appliance on the back page of
these operating instructions.
1
13