Table of Contents
Advertisement
Menu
UTIL
AUTO FIND
(UTILITIES)
(ABDL only)
SCAN MODE
ALARM
ALARM HIGH
ALARM LOW
DIFFERENTIAL
XFER
BACKUP
(TRANSFER)
SETUPS
RESTORE
SETUPS
BACKUP DATA
RESTORE
DATA
ABOUT
Function
Automatically
measurement is out of the viewable display area.
Enables a high speed scan mode that increases the overall
sample rate from 25 to 50 measurements per second,
depending on the current measurement mode used.
Toggles alarm mode ON, OFF, or AUDIBLE.
Sets the HI limit parameter. If the measurement exceeds
this value, a red light will illuminate and the alarm will
sound.
Sets the LOW limit parameter. If the measurement falls
below this value, a red light will illuminate and the alarm will
sound.
Sets a nominal value and your gauge will display +/- the dif-
ference from this nominal value.
Allows you to backup the setups currently stored in your
gauge to a computer via the RS232 port.
Allows you to restore setups saved on a computer to your
gauge via the RS232 port.
Allows you to backup grids or sequential log files stored in
your gauge to a computer via the RS232 port.
Allows you to restore grids or sequential log files saved on
a computer to your gauge via the RS232 port.
Provides Elcometer NDT contact information and your
gauge software version.
Refer to the help section of your gauge NDT Link software
for a complete electronic manual covering data transfer.
Description
locates
the
detection
point
if
the
35
Advertisement
Table of Contents
