Elcometer CG100ABDL Operating Instructions Manual page 35

Menu
GT2 GATE2 WIDTH
(GATE 2)
(ABDL only)
HOLDOFF 2
THRESHOLD2
GT3 GATE3 WIDTH
(GATE 3)
(ABDL only)
HOLDOFF 3
THRESHOLD3
SET OPEN
(SETUP)
SAVE
DELETE
DEFAULT
SETUP
LANGUAGE
DATA NEW
(DL only)
EDIT
OPEN
CLOSE
DELETE ONE
FILE
DELETE ALL
DATA
Function
Sets the overall width of the gate, in terms of distance, from
the starting value of HOLDOFF 2.
Delay the starting point of Gate2 a specific distance from the
first detection point found inside of the boundaries of the
Gate 1 settings. If no detection is found, the value of GATE1
WIDTH is used as a starting value for Gate2.
Sets the sensitivity level of Gate2. The amplitude of the
signal must reach or exceed this threshold level before a
measurement is detected.
Sets the overall width of the gate, in terms of distance, from
the starting value of HOLDOFF 3.
Delay the starting point of Gate3 a specific distance from the
first detection point found inside of the boundaries of the
Gate2 settings. If no detection is found, the value of GATE2
WIDTH is used as a starting value for Gate3.
Sets the sensitivity level of Gate3. The amplitude of the
signal must reach or exceed this threshold level before a
measurement is detected.
Displays a list of factory and user-defined setups currently
stored in memory. These setups can be recalled and used
at any time.
Save a custom setup that you have modified or created.
Delete specific setups previously saved in memory.
Loads a basic default setup. Use only as a last resort if the
setups in your gauge have been corrupted and a computer
is not accessible.
Select the menu language
Creates a new alpha numeric grid, or sequential log file
with auto identifiers. You can customise the grid or sequen-
tial log file according to your requirements.
Modify the parameters of grid or sequential files previously
saved.
Note: Predefined coordinates cannot be changed once they
have been created.
Recalls existing grids or sequential log files from gauge
memory.
Closes a currently opened grid or sequential log file.
Deletes a selected grid or sequential log file from memory.
Deletes all files currently stored in memory.
Description
34