Table of Contents
Advertisement
It is sometimes necessary to rename a previously saved setup, or add additional comments about
a particular setup. The other comments about the project may also be required for additional
documentation purposes.
The following procedures outline the necessary steps for saving and editing a setup:
1. Press MENU, SET and SAVE
2. Press ENTER to display the Save Setup edit box.
3. Scroll to NAME and then press ENTER to edit its value:
•
When you have finished, press OK to enter the value.
4. If you want to add a note, repeat step 3 for NOTE.
5. When you have finished, scroll to SAVE SETUP and press ENTER.
The setup list screen is displayed.
6. Scroll through the list of setups until the required location to save the
setup is highlighted.
7. Press OK to activate the confirmation screen.
8. Press OK to save the Setup, or ESC to cancel.
Note: The Name and Note parameters of a Setup can be edited at any time
by repeating the Save Setup routine described above. Therefore, the Save
Setup function can also be considered an Edit Function.
14.3 DELETING A SAVED SETUP
This option deletes a setup file from your gauge (for example, if it is no longer
needed).
1. Press MENU, scroll to the SET menu and then highlight the DELETE function.
2. Press ENTER to display the SETUP LIST BOX.
3. Scroll through the list of setups until the required setup is highlighted.
4. Press ENTER to activate the confirmation screen.
5. Press OK to delete the setup from memory.
14.4 USING THE DEFAULT SETUP
Your gauge includes a default setup which you can use if there are no other setups stored in the
gauge and you need to reset it to factory settings. This gives you the ability to load and modify a
basic setup as follows:
1. Press MENU, scroll to the SET menu and then highlight the DEFAULT SETUP function.
2. Press ENTER to activate the confirmation screen.
3. Press OK to confirm.
4. Press OK again to confirm.
15 DATA TRANSFER SOFTWARE
Software is available which allows data to be transferred from your gauge to a PC. Presently
Elcometer supplies NDT Link software for this purpose.
To set-up other types of communications software:
1. Start the communications software.
2. Configure the software using the following parameters:
Data Bits - 8, Parity - None, Stop Bits - 1, Baud Rate 1200 (to print a report), or 9600 to
transfer data file.
26
Advertisement
Table of Contents
