Table of Contents
Advertisement
14.1 OPENING A SETUP
1. Select MENU/SETUP/OPEN and press ENTER to display the SETUP
LIST BOX.
2. Scroll through the list of setups until the required setup is highlighted.
3. Press ENTER to activate the confirmation screen.
4. Press OK to load the setup from memory.
5. Press MEAS to return to the measurement screen.
14.2 SAVING AND EDITING A SETUP
Once the parameters and features have been adjusted for an application,
you can save these setting to a specific setup location for future use.
It is sometimes necessary to rename a previously saved setup, or add
additional comments about a particular setup. The other comments about the project may also be
required for additional documentation purposes.
The following procedures outline the necessary steps for saving and editing a setup:
1. Select MENU/SETUP/SAVE and press ENTER to display the SAVE SETUP EDIT BOX.
2. Scroll to NAME and then press ENTER to edit its value:
•
When you have finished, press OK to enter the value.
3. If you want to add a note, repeat step 2 for NOTE.
4. When you have finished, scroll to SAVE SETUP and press ENTER.
The setup list screen is displayed.
5. Scroll through the list of setups until the required location to save the
setup is highlighted.
6. Press OK to activate the confirmation screen.
7. Press OK to save the SETUP, or ESC to cancel.
Note: The Name and Note parameters of a Setup can be edited at any time
by repeating the Save Setup routine described above. Therefore, the Save
Setup function can also be considered an Edit Function.
14.3 USING THE DEFAULT SETUP
Your gauge includes a default setup which you can use (as a last resort) if
there are no other setups stored in the gauge. This gives you the ability to
load and modify a basic setup as follows:
1. Select MENU/SETUP/DEFAULT SETUP and press ENTER to activate the confirmation
screen.
2. Press OK to confirm.
3. Press OK again to confirm.
15 DATA TRANSFER SOFTWARE
Software is available which allows data to be transferred from your gauge to a PC. Presently
Elcometer supplies ElcoMaster 2.0™ software for this purpose.
To set-up other types of communications software:
1. Start the communications software.
2. Configure the software using the following parameters:
Data Bits - 8, Parity - None, Stop Bits - 1, Baud Rate 1200 (to print a report), or 9600 to
transfer data file.
Note: A report can be printed to a communications program (i.e. HyperTerminal), or printed to
a serial printer using A4 or 8.5" x 11" paper.
20
Advertisement
Table of Contents
