Lldp Commands - D-Link xStack DGS-3612G series Cli Manual

xStack
The LLDP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
The Link Layer Discovery Protocol (LLDP) specified in this standard allows stations attached to an 802 LAN to advertise to other
stations attached to the same 802 LAN the connectivity and management information necessary to identify to those management
entities the station's point of attachment to the 802 LAN. The information distributed via this protocol is stored by its recipients in a
standard management information base (MIB), making it possible for the information to be accessed by a network management
system (NMS) using a management protocol such as the Simple Network Management Protocol (SNMP)
Command
enable lldp
disable lldp
config lldp
config lldp
config lldp
config lldp
config lldp
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp
show lldp
show lldp mgt_addr
show lldp ports
show lldp local_ports
show lldp remote_ports
show lldp statistics
show lldp statistics
ports
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
message_tx_interval <sec 5-32768>
message_tx_hold_multiplier <int 2–10>
tx_delay <sec 1-8192>
reinit_delay <sec 1-10>
notification_interval <sec 5-3600>
[<portlist>|all] notification [enable | disable]
[<portlist>|all] admin_status [tx_only | rx_only | tx_and_rx |
disable]
[<portlist>|all] mgt_addr [ipv4 <ipaddr> | ipv6 <ipv6addr>] [enable
| disable]
[<portlist>|all] basic_tlvs [all | {port_description | system_name |
system_description | system_capabilities}] [enable | disable]
[<portlist>|all] dot1_tlv_pvid [enable | disable]
[<portlist>|all] dot1_tlv_protocol_vid [vlan [all | <vlan_name 32> ] |
vlanid <vid_list> ] [enable | disable]
[<portlist>|all] dot1_tlv_vlan_name [vlan [all | <vlan_name 32> ] |
vlanid <vid_list> ] [enable | disable]
[<portlist>|all] dot1_tlv_ protocol_identity[all | { eapol | lacp | gvrp |
stp}] [enable | disable]
[<portlist>|all] dot3_tlvs [all | {mac_phy_configuration_status | link
aggregation | maximum_frame_size}] [enable | disable]
forward_message [enable | disable]
{[ipv4 <ipaddr> | ipv6 <ipv6addr>]}
{<portlist>}
{<portlist>} {mode [brief | normal | detailed]}
{<portlist>} {mode [brief | normal | detailed]}
{<portlist>}
423
57
LLDP C
OMMANDS