D-Link xStack DGS-3612G series Cli Manual page 437

xStack
DGS-3627:5#config lldp forward_message enable
Command: config lldp forward_message enable
Success.
DGS-3627:5#
show lldp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the LLDP system level configuration status:
DGS-3627:5#show lldp
Command: show lldp
LLDP System Information
Chassis ID Subtype
Chassis ID
System Name
System Description
System Capabilities
LLDP Configurations
LLDP Status
LLDP Forward Status
Message Tx Interval
Message Tx Hold Multiplier: 4
ReInit Delay
Tx Delay
Notification Interval
DGS-3627:5#
show lldp mgt_addr
Purpose
Syntax
Description
Parameters
Restrictions
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
This command displays the switch's general LLDP configuration
status.
show lldp
This command displays the switch's general LLDP configuration
status.
None.
None.
Used to display the LLDP management address information.
show lldp mgt_addr {[ipv4 <ipaddr> | ipv6 <ipv6addr>]}
Displays the LLDP management address information.
ipv4 – The IP address of IPv4.
Ipv6 – The IP address of IPv6.
None.
: MAC Address
: 00-19-5B-F5-26-C0
:
: Gigabit Ethernet Switch
: Repeater, Bridge
: Disabled
: Disabled
: 30
: 2
: 2
: 5
434