D-Link xStack DGS-3612G series Cli Manual page 68

xStack
show config
Parameters
Restrictions
Example usage:
To view the current configuration settings:
DGS-3627:5#show config active
Command: show config active
#------------------------------------------------------------------
#
#
#
#
#
#------------------------------------------------------------------
# STACK
## stacking config information
## #Box
## #ID
## #--- ----------- ----- -----
## #
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
1. Basic (serial port, Telnet and web
management status)
2. Storm control
3. IP group management (Single
IP)
4. Syslog
5. QoS
6. Port mirroring
7. Traffic segmentation
8. Port
9. Port lock
10. Time Range
11. ACL
12. IP-MAC address binding
13. VLAN
14. 802.1X
15. FDB
16. MAC address table notification
17. STP
18. Safeguard Engine
19. Banner and Prompt
20. SSH
active – Entering this parameter will display configurations entered without being
saved to NVRAM.
boot_up − Entering this parameter will display configurations that are to be used
upon the next reboot of the Switch.
drive_id – Enter the drive ID number where the firmware file is located on the flash
drive that is to be viewed.
<pathname 64> − The user may enter the path and file name of a configuration file
located on the flash memory of the Switch, which will then be displayed
Only Administrator-level users can issue this command.
DGS-3627 Gigabit Ethernet Switch
Configuration
Firmware: Build 2.50.B15
Copyright(C) 2009 D-Link Corporation. All rights reserved.
Type Exist rity
1 DGS-3627 exist 32
21. SNTP
22. LACP
23. IP
24. IGMP snooping
25. MLD Snooping
26. Access Authentication Control
27. AAA
28. ARP
29. Static Route
30. Policy Route
31. IGMP
32. PIM
33. DVMRP
34. RIP
35. MD5
36. OSPF
37. DNSR
38. DHCP Relay
39. VRRP
Prio-
65