Dns Commands - D-Link xStack DGS-3612G series Cli Manual

xStack
The DNS relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
config dnsr
enable dnsr
disable dnsr
show dnsr
Each command is listed, in detail, in the following sections.
config dnsr
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set IP address 10.43.21.12 of primary.
DGS-3627:5#config dnsr primary 10.43.21.12
Command: config dnsr primary 10.43.21.12
Success
DGS-3627:5#
Example usage:
To add an entry domain name dns1, IP address 10.43.21.12 to DNS static table:
DGS-3627:5#config dnsr add static dns1 10.43.21.12
Command: config dnsr add static dns1 10.43.21.12
Success.
DGS-3627:5#
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
[[primary | secondary] nameserver <ipaddr> | [add | delete] static
<domain_name 32> <ipaddr>]
{[cache | static]}
{[cache | static]}
{static}
Used to configure the DNS relay function.
config dnsr [[primary | secondary] nameserver <ipaddr> | [add |
delete] static <domain_name 32> <ipaddr>]
This command is used to configure the DNS relay function on the Switch.
primary − Indicates that the IP address below is the address of the
primary DNS server.
secondary − Indicates that the IP address below is the address of the
secondary DNS server.
nameserver <ipaddr> − The IP address of the DNS nameserver.
[add | delete] – Indicates whether to add or delete the DNS relay
function.
<domain_name 32> − The domain name of the entry.
<ipaddr> − The IP address of the entry.
Only Administrator and Operator-level users can issue this command.
325
42
DNS C
OMMANDS