xStack
The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command
create arpentry
delete arpentry
show arpentry
config arp_aging time
clear arptable
config arpentry
config gratuitous_arp
send ipif_status_up
config gratuitous_arp
send
dup_ip_detected
config gratuitous_arp
learning
enable gratuitous_arp
disable
gratuitous_arp
config gratuitous_arp
send periodically ipif
show gratuitous_arp
Each command is listed, in detail, in the following sections.
create arpentry
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a static ARP entry for the IP address 10.48.74.121 and MAC address 00:50:BA:00:07:36:
DGS-3627:5#create arpentry 10.48.74.121 00-50-BA-00-07-36
Command: create arpentry 10.48.74.121 00-50-BA-00-07-36
Success.
DGS-3627:5#
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
<ipaddr> <macaddr>
[<ipaddr> | all]
{ipif <ipif_name 12> | ipaddress <ipaddr> | static}
<value 0-65535>
<ipaddr> <macaddr>
[enable|disable]
[enable|disable]
[enable|disable]
{ipif <ipif_name 12>} {trap |log }
{ipif <ipif_name 12>} {trap |log}
<ipif_name 12> interval <value 0-65535>
{ipif <ipif_name 12>}
Used to make a static entry into the ARP table.
create arpentry <ipaddr> <macaddr>
This command is used to enter an IP address and the
corresponding MAC address into the Switch's ARP table.
<ipaddr> − The IP address of the end node or station.
<macaddr> − The MAC address corresponding to the IP address
above.
Only Administrator and Operator-level users can issue this
command. The Switch supports up to 255 static ARP entries.
ARP
G
AND
RATUITOUS
301
38
ARP C
OMMANDS