D-Link xStack DGS-3612G series Cli Manual page 231

xStack
Example usage:
To show the limited multicast address on ports 1 to 2:
DGS-3627:5#show limited multicast address 1-2
Command: show limited multicast address 1-2
Port :
State :
Access :
No.
----
Port :
State :
Access :
No.
----
DGS-3627:5#
create multicast_range
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create the multicast range "accounting":
DGS-3627:5#create multicast_range accounting from 224.19.62.34 to
224.19.62.200
Command: create multicast_range accounting from 224.19.62.34 to
224.19.62.200
Success.
DGS-3627:5#
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
1
Disabled
None
Name
----------------
2
Disabled
None
Name
----------------
Used to create a range of multicast IP addresses that will be specified under a
given name.
create multicast_range <range_name 32> from <multicast_ipaddr> to
<multicast_ipaddr>
This command will create a multicast range of IP addresses that will be
specified under a given name. Once created, this range name can be added
to the config limited_multicast_addr command, therefore setting a list of
multicast addresses that will be permitted or denied by the switch.
<range_name 32> − Enter a name of up to 32 alphanumeric characters that
will be used to identify this multicast range.
from <multicast_ipaddr> − Enter the beginning IP address of the multicast
range.
to <multicast_ipaddr> − Enter the ending IP address of the multicast range.
Only Administrator and Operator-level users can issue this command.
From
-----------------
From
-----------------
228
To
-------------
To
-------------