D-Link xStack DGS-3612G series Cli Manual page 316

xStack
config vrrp ipif
Restrictions
Example usage:
To set the authentication type for a VRRP entry:
DGS-3627:5#config vrrp ipif Zira authtype simple authdata tomato
Command: config vrrp ipif Zira authtype simple authdata tomato
Success.
DGS-3627:5#
show vrrp
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To view the global VRRP settings currently implemented on the Switch (VRRP Enabled):
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
ip authdata <string 16> – This parameter will require the user to set
an alphanumeric authentication string of no more than 16 characters
to generate a MD5 message digest for authentication in comparing
VRRP messages received by the router. If the two values are
inconsistent, the packet will be dropped.
Only Administrator and Operator-level users can issue this
command.
To view the VRRP settings set on the Switch.
show vrrp {ipif <ipif_name 12> {vrid <vrid 1-255>}}
This command is used to view current VRRP settings of the VRRP
Operations table.
ipif <ipif_name 12> – Enter the name of a previously configured IP
interface for which to view the VRRP settings. This IP interface must
be assigned to a VLAN on the Switch.
vrid <vrid 1-255> – Enter the VRRP ID of a VRRP entry for which to
view these settings.
None.
313