Section 7 − Operating Auxiliary Equipment; Generator Power Receptacles And Supplementary Protectors - Miller Trailblazer 325 Diesel Owner's Manual

SECTION 7 − OPERATING AUXILIARY EQUIPMENT

7-1. Generator Power Receptacles And Supplementary Protectors

3
!
Use GFCI protection when operat-
ing auxiliary equipment. If unit does
not have GFCI receptacles, use
GFCI-protected extension cord. Do
not use GFCI receptacles to power
life support equipment.
!
Unplug power cord before attempt-
ing to service accessories or tools.
.
Generator power decreases as weld
current increases.
1 120/240 V 50 A AC Receptacle RC1
2 120 V 20 A AC Receptacles RC2
and RC3 (GFCI Receptacles Shown)
!
Test GFCI monthly. See Section 7-2
for GFCI information and for reset-
ting and testing procedures.
.
Complete Parts List available at www.MillerWelds.com
1
RC1 supplies 60 Hz single-phase power at
weld/power speed. Maximum output is
12.0 kVA/kW.
RC2 and RC3 supply 60 Hz single-phase
power at weld/power speed. Maximum out-
put from RC2 or RC3 is 2.4 kVA/kW.
3 Supplementary Protector CB1
CB1 protects standard receptacles RC1,
RC2, and RC3 from overload (for Excel
power information, see Section 7-3). If CB1
opens, the receptacles do not work. Place
switch in On position to reset.
4 Supplementary Protector CB2
CB2 protects RC2 from overload. If CB2
opens, RC2 does not work.
5
4
2
5 Supplementary Protector CB3
CB3 protects RC3 from overload. If CB3
opens, RC3 does not work.
.
Press button to reset supplementary
protector. If supplementary protector
continues to open, contact Factory Au-
thorized Service Agent.
Combined output of all receptacles limited
to 12.0 kVA/kW rating of the generator.
EXAMPLE: If 20 A is drawn from each 120
V duplex receptacle, only 30 A is available
at the 120/240V receptacle:
2 x (120 V x 20 A) + (240 V x 30 A) = 12.0
kVA/kW
OM-258900 Page 37
Ref. 248 009