Kyocera KM-2810 Service Manual page 91

Protocol Detail
1. Select [Network Setting] using the cursor up/down
keys.
2. Press the OK key.
3. Select [TCP/IP Settings] using the cursor up/down
keys.
4. Press the OK key.
5. Select [Protocol Detail] using the cursor up/down
keys.
6. Press the OK key.
7. Select the item for which you want to make set-
tings.
8. Select [On] or [Off].
9. Press the OK key.
Network Security
SSL Setting
1. Select [Network Setting] using the cursor up/down
keys.
2. Press the OK key.
3. Select [Secure Protocol] using the cursor up/down
keys.
4. Press the OK key.
5. Select [SSL] using the cursor up/down keys.
6. Press the OK key.
7. Select [On] or [Off].
8. Press the OK key.
IPP Security
1. Select [Network Setting] using the cursor up/down
keys.
2. Press the OK key.
3. Select [Secure Protocol] using the cursor up/down
keys.
4. Press the OK key.
5. Select [IPP Security] using the cursor up/down
keys.
6. Press the OK key.
7. Select [IPP/IPP over SSL] or [IPPoverSSL only].
8. Press the OK key.
HTTP Security
1. Select [Network Setting] using the cursor up/down
keys.
2. Press the OK key.
3. Select [Secure Protocol] using the cursor up/down
keys.
4. Press the OK key.
5. Select [HTTP Security] using the cursor up/down
keys.
6. Press the OK key.
7. Select [HTTP/HTTPS] or [HTTPS only].
8. Press the OK key.
LDAP Security
1. Select [Network Setting] using the cursor up/down
keys.
2. Press the OK key.
3. Select [Secure Protocol] using the cursor up/down
keys.
4. Press the OK key.
5. Select [LDAP Security] using the cursor up/down
keys.
6. Press the OK key.
7. Select [Off], [LDAPv3/TLS] or [LDAP over SSL].
8. Press the OK key.
LDAP Security
1. Select [Network Setting] using the cursor up/down
keys.
2. Press the OK key.
3. Select [IPSec] using the cursor up/down keys.
4. Press the OK key.
5. Select [On] or [Off].
6. Press the OK key.
Interface Block Setting
USB Host (USB memory slot setting)
1. Select [I/F Block Set.] using the cursor up/down
keys.
2. Press the OK key.
3. Select [USB Host] using the cursor up/down keys.
4. Press the OK key.
5. Select [Unblock] or [Block].
6. Press the OK key.
USB Device (USB interface setting)
1. Select [I/F Block Set.] using the cursor up/down
keys.
2. Press the OK key.
3. Select [USB Device] using the cursor up/down
keys.
4. Press the OK key.
5. Select [Unblock] or [Block].
6. Press the OK key.
Optional interface (Optional interface card setting)
1. Select [I/F Block Set.] using the cursor up/down
keys.
2. Press the OK key.
3. Select [Option I/F] using the cursor up/down keys.
4. Press the OK key.
5. Select [Unblock] or [Block].
6. Press the OK key.
2H9-1
1-3-65