Kyocera KM-2810 Service Manual page 140

2H9
5. Remove the connector.
6. Remove the screw and then remove the
inverter PWB.
7. Check or replace the inverter PWB and refit
all the removed parts.
Caution: Replace F1 with a fuse rated 250 V
ac, 0.75 A, non-time delay, (when F1 fuse is
replaced.)
8. Unhook three hooks and then remove the
ISU reflector.
9. Remove the exposure lamp from the hold-
ers.
10. Check or replace the exposure lamp and
refit all the removed parts.
1-5-28
F1
CN1
Inverter PWB
Figure 1-5-41
ISU reflector
Hook
Figure 1-5-42
Exposure lamp
Holder
Figure 1-5-43
Inverter PWB
Connector
Hook
Hook
Lamp mount
Screw
Holder