Options Programming - CrimeStopper EZEE Start EZ-10 Installation Instructions Manual

NOTES: (1) Options #2, #4 and #5 DO NOT APPLY TO THE EZ-10 MODEL (NO KEYLESS ENTRY)
(2) For EZ-10 Model, tap the Brake Pedal to select/toggle the option values.
Option Option Description
#
1. Tach or Tachless Mode
2. Autolock with RPM/Ignition
3. OEM Disarm/Unlock Pulse
4. Double Unlock Pulse
5. Lock During and After
Remote Start Abort
6. Diesel Glow Plug Delay
7. Remote Start Engine Run
Time
8. Option reset
OPTION DESCRIPTIONS:
1. Tach or Tachless Mode:
This option sets how the unit monitors your engine. You can program either for Tach mode in which the unit uses a
Tach signal (RPM) or for Tachless mode that monitors voltage level. See pages 11-12 for more information and
additional steps for actual Tach learning and Tach finder modes. The system will only learn Tach when the engine is
running and the tach wire is connected to an A/C tach source.

OPTIONS PROGRAMMING

Option Values
Tach = Engine RPM
Tachless = Voltage monitor
ON or OFF
0.75 sec. Normal or 0.5 Shorter
Single or Double Unlock Pulse
ON or OFF
Lock button = 10 Sec.
Unlock button = Gas 3 sec
Delay
Tap Brake 3X = 20 Sec.
Start Button = 30 Sec.
Lock Button = 12 Min.
Unlock Button = 24 Min.
Tap Brake Pedal 3X = 36 Min.
Start Button = 48 Min.
Unlock Button
14
* = Default Value
Button #1 Button #2
LOCK UNLOCK
Tach Tachless*
ON *OFF
Short *Normal
Double *Single
OFF *ON
10 Sec. *Normal
(3 sec. delay)
12 Min. *24 Min.
Reset to
Default