Options Programming - CrimeStopper Cool Start RS-1300DP Installation Instructions Manual

To Engage Option Programming:
1. Open hood (If no hood pin switch is installed, then ground the Gray wire)
2. Turn Key to the ON position. (Do not start vehicle) Pink wire must be connected!
3. Press the program / valet button 5 times. Wait for the unit to flash the lights and/or horn honk 5 times.
4. Push the valet/program button the number of times that corresponds to the option number desired (1-22X). You
must get a light flash and/or honk after each button press. If the system did not flash the lights and/or honk, then it
did not register your press. Press carefully and do not lose count.
5. A) For RS1300/1/3/4DP or 1604TW1/1704TW2/1804FM: When you reach the desired option #, Press button
#1(Lock) or #2 (Unlock) to change the option. (Some option numbers use ALL 4 remote buttons to select settings)
5. B) For RS-1300DP: (No remotes) Tap the brake pedal to toggle through the option values: Tap the brake once
(lights flash 1X; Tap the brake pedal again (Lights flash 2X) tap 3 or 4 times for options that have 3 or 4 values.
6. When finished, turn Ignition OFF, close hood (or un-ground Gray wire) and check for changed features.
Option Option Description
#
1. Engine Monitoring
2. Autolock with RPM/Ignition
3. Door Lock Pulse Time
4. Double Unlock Pulse
5. OEM Interface
(RS1300 MODEL ONLY)
6. Double button press for remote
start and Trunk release
7. Horn Chirps on remote start
8. Lock During and After
Remote Start Abort
9. Tan Wire Output function
10. "Wake up" Pulse on Unlock
(1-sec +12V to IGN)

OPTIONS PROGRAMMING

Option Values
Tach (Engine RPM) or Tachless
ON (RPM/Ignition) or OFF.
0.75 Sec. (Standard) OR
3.0 Sec. (European Vacuum)
Single or Double Unlock Pulse
Remote Start w/Single Pulse or
3 Pulses on Green input wire
ON or OFF
ON or OFF
ON or OFF
Trunk or Dome Light Output
ON or OFF
17
* = Default Value
Button #1 Button #2
LOCK UNLOCK
Tach Tachless*
ON *OFF
3 Sec. *0.75 Sec.
Double *Single
3 pulse *1 Pulse
ON *OFF
ON *OFF
OFF *ON
Dome *Trunk
ON *OFF