Options Programming - CrimeStopper Cool Start RS-00 Installation Instructions Manual

To Engage Option Programming:
1. Open hood, If no hood pin switch is installed, then ground the Gray hood pin wire. Turn Key to the ON position. Do not
start vehicle (Pink wire must be connected!)
2. Press the program Valet button 5 times. Wait for the unit to flash the lights and/or horn honk 5 times.
3. Push the valet program button the number of times that corresponds to the option number desired (1-23X). You
must get a light flash and/or honk after each button press. If the system did not flash the lights and/or honk, then it
did not register your press. Press carefully and do not lose count.
4. For RS-1, RS-3, RS-4: When you reach the desired option #, Press button #1 Lock or #2 Unlock to change the
option. (Some option numbers use ALL 4 remote buttons to select settings)
5. For RS-00, RS-1: (No Lock button) Tap the brake pedal to toggle through the option values: Tap brake once
(lights flash 1X) Tap the brake pedal again (Lights flash 2X) tap 3 or 4 times for options that have 3 or 4 values.
6. When finished, turn Ignition OFF, close hood (or un-ground Gray hood pin wire) and check for changed features.
Option
Option Description
#
1 Engine Monitoring
2 Autolock with RPM/Ignition
3 Door Lock Pulse Time
4 Double Unlock Pulse
5 Data Port Protocol OFA or SL Series
Remote Start & Auxiliary Output
6
Button Press Selection
7 Horn Chirps on Remote Start
8 Lock After Remote Start/Abort
OPTION PROGRAMMING
RS-1, RS-3, RS-4 OPTION PROGRAMMING TABLE
TX Button #2
TX Button #1
Default Value
Learn Tach *Tachless*
ON
3 Sec. *0.50 Sec.*
2 Pulses *1 Pulse*
OFA Series *SL Series*
Double Button
*½ Second Press*
Press
ON
OFF
16
TX Button
#3
*OFF*
Press and
Hold
*OFF*
*ON*
TX Button
#4