Transmitter Programming - CrimeStopper EZEE Start EZ-10 Installation Instructions Manual

Transmitter Code Learning:
Notes: Remote Transmitters come pre-programmed from the Factory. When re-learning remotes or adding remotes,
ALL your system's remote codes must be learned at time of programming!! These systems allow storage of up to 4
different remote codes in memory. Antenna / Receiver must be plugged into unit.
1. Open hood (ground the Gray hood pin wire if no hood pin is installed.)
2. Turn key to the ON position. (Do not start vehicle)
3. Press Program/Valet button 4 times. After a few seconds, the unit will flash the parking lights 4 times.
4. EZ-30: Press Button #1 (Lock) of the transmitter to be learned. EZ-10 Model: Press Engine Start button. You should
get 2 light flashes indicating the code-learn. Now the unit is waiting for a 2
up to 3 additional remotes. The unit will flash the lights in succession after each code learned for up to 4 codes. (2
nd
flashes for the 2 code, 3 flashes for the 3
learning mode, otherwise turn key OFF and close the hood. (See Diagram Below)
(GRAY WIRE GROUNDED)
EZ-30
PRESS
LOCK BUTTON
EZ-30/10 TRANSMITTER CODE LEARNING
rd
code etc.) If all 4 codes are learned, the unit will automatically exit code
IGN
OFF
EZ-10
PRESS
START BUTTON
nd
code, so repeat this step as needed with
PRESS 4X's
FLASH 2, 3, or 4 X's
16
WAIT FOR
4 FLASHES
IGN
OFF
COMPLETE