Table of Contents
Advertisement
Control Panel Page Remote Control Items
Group
Refresh (Button)
Projector Status Projector Status
Error Info
Power Off (Button)
Power On (Button)
Projector
Input
Control
3D
Color Mode
Blank
Aspect Ratio
Brightness
Contrast
ECO Mode
Audio Volume
Mute Audio
Audio Out
Initialize (Button)
Item
Click to refresh the screen with the latest information.
Shows the projector's current status as either "ON" or "Standby".
Shows one of the following.
No Error: Operating normally.
Temperature Error: Temperature error occurred.
Fan Error: Fan error occurred.
Light Error: Light source unit error occurred.
Other Error: Error other than above occurred.
Click to turn the projector off.
Click to turn on the projector. This operation is supported only when
"Enable" is selected for "Remote On".
Specifies the input source.
Click to enter or exit the 3D input mode.
Specifies the color mode.
Selecting "ON" for this setting temporarily blocks the image from the
input source. "OFF" causes the image from the input source to be
projected.
Changes the aspect ratio of the projected image.
Input a value into the box and then click the [Apply] button. This will
change the projector's "Brightness" setting accordingly.
Input a value into the box and then click the [Apply] button. This will
change the projector's "Contrast" setting accordingly.
Switches the Eco mode.
Input a value into the box and then click the [Apply] button. This will
change the volume setting accordingly.
Specifies the mute setting. Audio is output while "OFF" is selected for this
setting, and muted when "ON" is selected.
Specifies either output from the projector's speaker or AUDIO OUT
terminal for audio.
Speaker: Audio output from the speaker
Line: Audio output from the AUDIO OUT terminal
Click to return all Network Projection Control items, except for the
"Projector Status" items, to their initial factory defaults.
Description
66
Advertisement
Table of Contents
